Published in the 2009-05-02 09:32:24 The quick reply Only look at the building Collect this post Direct messages the building share The printer nozzle clogging how to solve Along with the gradually popularization of the digital camera the figure of inkjet printers are becoming more and more can be seen everywhere.In enjoy inkjet printer brings us convenient at the same time, we also often encounter inkjet printers print color distortion, the handwriting of fuzzy failure phenomenon, such as serious when there will be unable to print. This failure phenomenon occurs, mostly inkjet printer nozzle was blocked the ink, for example when an inkjet printer for a long time to place without being used, the print heads of ink caused by weathering phenomenon or moisture evaporation ink into a class, or an inkjet printer as mixed in different periods of several different brands of ink, ink after mixed because there was a chemical reaction, also easy to cause print nozzle clogging phenomenon.It is obvious that if inkjet printer nozzle blockage, inkjet printers, often can't be normal print operation;?So in the face of print nozzle clogging phenomenon, how can we can make plug nozzle recover! Next, this article is for you to print user contribution two tips, to help you efficiently eliminate the congestion state of print heads quickly let the working state of the inkjet printer back to normal Yourself, let the plug nozzle back to normal.When we found that the inkjet printer to print out the contents of the bolt or rift of phenomenon, but there are still a lot of residual ink printer cartridges, we must adopt the method of manual cleaning will clog in the nozzle rid of ink star class In the use of manual method were blocked the ink nozzle cleaning, we first need to carefully will be installed in ink cartridges out of, and carefully observe the presence of integrated circuit part at the bottom of the cartridge, the area of the location is the location of the nozzle;. Then took a cup, and pour in some warm water around 60 degrees Celsius, and place the IC part at the bottom of the cartridge to soak in warm water for 20 minutes or so, here need to remind you note that we will have to be integrated circuit part at the bottom of the cartridge immerse into the water, and never will the ink cartridges are soaked in water;. When the nozzle part of ink with soak in warm water for more than 20 minutes later, we must promptly remove ink cartridges from the water, and then forced to attached on the surface of the nozzle, water clean, we will find that in the process of water in a sling nozzle location will be out of some ink, along with all at this time we can use clean cotton cloth to wipe out the ink and then clean the successful cartridges in the correct way to reinstall the inkjet printer ink cartridge, finally, we might as well the test page prints out to perform the operation, look at the print heads at this time whether can work normally. In actual use in the process of inkjet printers, 52, there are other printing on the hardware user tend to frequent the ink cartridge from printer cartridges to remove, so it is easy to print nozzle serious jam phenomenon, even the internal part of the ink cartridges can also occur dry phenomenon, the printer will generally appear unable to print the phenomenon!
http://www.juexiang.comin-china.com/catalogs/70/inkjet_printhead.html